2026.04.16 – Industrial Cone Fabrication

A client required a large industrial cone fabricated from ¾” plate. Due to the overall length and geometry of the assembly, conventional fabrication would have required additional circumferential weld seams breaking the cone into shorter sections. Those extra seams introduce more fit-up work, welding time, distortion risk, and inspection requirements — and compromise the overall geometry of the finished cone.

The Kubes Steel team determined that by leveraging our 2,500-tonne × 40-foot brake press, the cone could be formed in three full-length sections — eliminating the need for mid-point circumferential welds entirely. Plate layout, forming sequence, and crane handling logistics were mapped out to ensure each long section could be accurately formed to the required taper geometry in a single press operation.

Each of the three cone sections was formed from ¾” plate using the 2,500T × 40ft brake press — the critical piece of equipment that made this approach possible. The sheer bed length of the press allowed the full section length to be formed accurately, producing consistent taper geometry that shorter equipment simply couldn’t achieve in a single hit.

By eliminating the circumferential weld seams, the cone was completed in three clean, full-length sections with perfect geometry throughout. The result was a structurally superior assembly, significantly reduced fabrication time, and a higher quality finished product — made possible by having the right equipment for the job.

Project Articles