Kubes Steel can fabricate a wide range of products, large and small. We recently formed these customized corrugated 3/8″ thick stainless steel sections which will be used for a marine break water.

At Kubes Steel, custom fabrication is our specialty. We can make almost anything you can imagine. Our wide range of equipment enabled our skilled operators to fabricate this Gas Flare Stack completely in-house, including delivery of the finished piece.

Kubes had to use a special setup to achieve the bends required by our customer when fabricating these staircase treads.

Kubes was selected as the fabricator to make these towers for electrical transmission lines. Each half is formed on our newest brake press and then welded together before shipping out to the installation site. Here, our operators are forming one of the halves and we can see a completed half as well.

Our forming methods are precise. We can custom bend and form all types of metal to any profile required. These troughs are pressed and then rolled from 1/4″ thick mild steel to become oil vats. These pieces are held to within 1/16” on the ends.

Kubes Steel installs a 2500 ton Pacific K-Series brake press at our main shop.

A steel plate that was brake press formed at Kubes Steel.

A cone is brake press formed at Kubes Steel.

Steel cones brake press formed from steel plate at Kubes Steel.